BUTTERFLY REFLECTIVE HEAT TRANSFER VINYL (HTV) DECALS – THE CUSTOM SHOP

4.6

(399)

Write Review

$ 4.50

Add to Cart

Qty

In stock

Description

Premium Quality Butterfly Reflective Shoe Heat Transfer HTV For Customising Trainers and Sneakers. We Have a Wide Variety of Designs Perfect For Any of Your Customising Needs. Shop Our Other Products such as Shoe Stencils / Vinyl Painting Stencils, Sticker Heat Transfers, Customising Tools, Mini Irons and More!
INFORMATION: - Very Bright & Strong Reflective! - Easy Weed Material - We recommend our Weeding Tool for an awesome experience. - Needs to be heat applied and activated. - Can be applied to many materials including: Leather, Plastic, Fabric, Wood, Glass and Metal. - Decal is Light Grey, but upon contact with light, it will be reflective. DIMENSIONS AND SIZE GUIDE: LARGE - W: 5.0cm H: 4.6cm (Good for Sizes 8 UK (9 US) and ABOVE) SMALL - W: 4.5cm H: 4.2cm (Good for Sizes 7 UK (8 US) and BELOW) SHIPMENT: Usually shipped out either the same day or the next working day. Further shipping information will provided at Checkout. REQUIRED EQUIPMENT: We recommend to use a mini-iron to apply the Heat Transfers. We sell a great quality Mini Iron in store. Make sure you preheat your iron for 7-10 minutes before you begin the application of the decals. HOW TO USE: 1. Weed the unwanted bits of vinyl. You can purchase one of our Weeding Tools in the Customizing Tools section. 2. You can deglaze the shoe surface with acetone or Angelus Deglazer and Preparer. 3. Place the decal where you want it. But make sure the plastic backing is facing up, towards you. You will be applying the heat to the plastic. The decal should be looking the correct way, not mirrored. 4. Set the iron to a low-medium heat, wait for it to heat for 5-10 minutes. Start applying heat using a mini-iron for about 10-20 seconds per area. You need to make sure you apply the heat to the side with the plastic. This will release the decal slowly from under the plastic cover onto the surface you're applying it to. Let the plastic cool a bit and then proceed to removing it, the decal will stay down on the surface of the shoes. 5. Press down with your fingers to settle it in properly, you can also apply heat from a heat gun or hair dryer after to melt it on further for a stronger hold. 6. As a last step, some choose to add a finisher such as the Angelus Matte Finisher to apply a thin layer of protection over the decals. This helps give more durability to the shoes. This does not lower the reflectiveness of the decals. If you are unsure of how to use these, get in contact with us at info@