Creality Falcon 2 Frame is Incorrect - LightBurn Hardware

If I set LightBurn to Current Position and then set the Job Origin to anything but the lower left corner, the machine frames in the wrong place. It always frames as if it were starting from Current Position but with the Job Origin in the lower left corner. I’m using a 22W Creality Falcon 2. I’m using G-Code files instead of a USB connection. Below is a picture of a scrap piece of cardboard I was running tests on to figure out alignment. You can see my pencil marked X, whcih I was trying to hit

Misalignment between the trace and the actual laser - GRBL

Cr-Laser Falcon Owners and Support

Xtool d1 10w ra2 rotary center point - LightBurn Hardware

【Powerful 40W Laser Output】Falcon2 laser engraving machine has an Output Power of up to 40W and a Machine Power of 240W. It can cut 20mm cork and

Creality Laser Engraver 40W Output, 240W High Power Falcon2 Laser Engraving Machine, DIY Laser Cutter and Engraver Machine for Metal and Wood, Paper

【Powerful Laser Cutter】With 10W output power, CR-Laser engraver can cut through 12mm wood board with one pass at a speed up to 10000mm/m. Even

10W Laser Engraver, Official Creality CR-Laser Falcon 72W Engraving & Cutting Machine, 0.06mm High Precision Laser Cutter for Cardboard, Wood

Error:20 Unsupported or invalid g-code - LightBurn Software

Wrecking a (scrap) YETI on Falcon 2 40W and Creality Roller. : r

Device Settings - LightBurn Software Documentation

Error:20 Unsupported or invalid g-code - LightBurn Software

CR-Laser Falcon - laser wont fire - LightBurn Software Questions

HOW TO FIX CREALITY FALCON 2 ENGRAVER OR LIGHTBURN NOT CONNECTING

Why doesn't light burn connect to my Creality Falcon 2 22w laser

Creality Falcon2 40W Laser Engraver & Cutter - Creality Falcon