That adjustment should be set once and left alone. Use lightburn to control the lps via the controller. If you change that adjustment it will throw off all of your known power settings. This might help… Good luck 😸
K40 Laser not Responding with laserburn - Board Configuration and
Laser head wont move - Board Configuration and Setup - Cohesion3D
K40 Not firing in auto - Smoothieware - LightBurn Software Forum
OMTech K40+ , Laser will not fire - Community Laser Talk
Lightburn, Smoothieware and cluster - Smoothieware - LightBurn
GBRL PWM Setting - It almost doesn't change the power - Board
Smoothieware on omtech k40, lightburn not controlling laser power
Laser isnt burning - Smoothieware - LightBurn Software Forum
Full Spectrum MLE-40 - Smoothieware - LightBurn Software Forum
Smoothieware on omtech k40, lightburn not controlling laser power
How to set up the SKR 1.3/1.4 Board with the K40 Laser - #34 by
Laser head wont move - Board Configuration and Setup - Cohesion3D
Alarm hard limit - Y - LightBurn Software Questions - LightBurn