Hello, I read lots of posts regarding Circles not round and do not meet but couldn’t see the same issue I experience. I am new to laser cutting and just assembled a Sculpfun S30 Pro (10W) with Y axis extension. When engraving / cutting the first test pattern, the cut circles are oval and there are strange lines off the circles (and rectangles too). I run some additional tests just on the cutting after adjusting the Y axis belt, but it made no difference. I then used LaserGRBL to make t
Circles not starting and stopping in exactly in the same place - LightBurn Software Questions - LightBurn Software Forum
Work Offset Issue? - LightBurn Hardware Compatibility - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum
Camera alignment drifting - LightBurn Hardware Compatibility - LightBurn Software Forum
Setting up Lightburn
Know About Lightburn Software: Cost and Features
Rotary table not recognized in light burn - Ortur Lasers - LightBurn Software Forum
Device Setup in LightBurn - Cohesion3D
Circle problems - Ortur Lasers - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum
Critical issue with new version 1.2.01 -- OFFSET + file compatibility - LightBurn Software Questions - LightBurn Software Forum
Offset of circle is not centered over original circle - LightBurn Software Questions - LightBurn Software Forum
Work Offset Issue? - LightBurn Hardware Compatibility - LightBurn Software Forum