I’m new to X1C and this is my 6 print. So far all prints looked pretty good but on this print it starting to fail. It printed the first layer and I got the dialog that says scanning first layer and once it finished it continued printed. As you can see from the results of the first layer, I would have expected it to stop. Is there something wrong with the printer or should I have done something different? Also, if anyone have suggestions to why the print came out that bad, it would be greatly ap
Scanning offset problems - LightBurn Software Questions
PETG Issues - Bambu Lab X1 Series - Bambu Lab Community Forum
3D printing First Layer issues troubleshooting Guide
First layer issues Prusa Knowledge Base
First layer issues : r/ender3v2
I've had this issue with many prints, where the first layer is
Second layer problem – Assembly and first prints troubleshooting
3D Printing Troubleshooting Guide
3D printing First Layer issues troubleshooting Guide
Having issues with first layer ever since switching to Klipper : r
Better First Layer and Bed Level Fixes on 3D Printers
Cutting Issues With Your Scan N Cut - Create With Sue
Problem with 1st layer after changing layer height – Assembly and